lasasero.blogg.se - Homeseer download

#Homeseer download install
#Homeseer download update
#Homeseer download upgrade

Reports of nodes requiring a power cycle to get them to talk again were coming in.

#Homeseer download upgrade

v1.10: SDK upgrade and reboot if no communication in 18hrs.

| Multilevel Switch doesn’t dim the LED, it only turns it on/off. | Multilevel Switch command class was added as required for support of the Color Command class for the color LED. | Configuration Command Class upgraded to V3 so the parameter names and information can be obtained directly from the device without the need for custom programming. Initial release using Sigma SDK 6.81.00 which adds security S2 and SmartStart.

v2.1: Upgrade to SmartStart – Z-Wave Certification rev.

| Various other small changes were required to pass certification but would not impact typical users. This is a change in the certification and the sensor MUST always send a sensor reading. | The parameter value of 0 is no longer valid for the sensor readings. ZWave Library 6.81.00 – ONLY FOR UNITS WITH SCREW TAB!Īdded the Supervision Command Class to the non-secure NIF.

#Homeseer download update

| To get the settings for the changes, please update to the latest Beta of the Z-Wave plugin 3.0.1.234 or later. Note that a central scene command for single taps IS still sent. When disabled, the load will respond instantly to paddle presses. | Ability to disable the multi-tap feature on both WS and WD. This allows other WX200 devices to used as companion switches. Any device added to group 2 will be controlled.

v5.12: Added a parameter to allow for lower dimming on the WD200.

This ensures that both dimmers LEDS stay in sync.

v5.13: When using group 2 association the controlling dimmer will send a BASIC SET to the associated dimmer after it reaches the desired dim level.

#Homeseer download install

If you install it on any other device, it may render that device inoperable. If it fails, do a connectivity check, then remove.Ĭareful: Be sure to install this dimmer firmware on the HS-WD200+ dimmer. After adding the switch back in, click on the old device then Z-Wave tab, then “Remove Bad Node” to remove the node from the Z-Wave interface. You will need to add the switch back into your network. This was an unfortunate consequence of adding the group 2 association feature. Note: When updating to this firmware the node ID of the switch will be lost. v5.14: Fixed multiple taps controlling the load (multiple taps should not control the load) | Modified parameter 5 to specify the lowest dim level the dimmer will provide (6.5% -> 20%) (Values are 1-14) | Z-Wave plugin version 3.0.1.249 required in order to set the lowest dim level parameter from the device Z-Wave settings.